![]() Back on the Win7 computer I tried using the command prompt to open altera\11.2sp2\quartus\bin\jtagconfig.exe and saw it read out the message "No JTAG hardware available". In troubleshooting, I also tried installing the same version of Quartus II and the USB blaster on my Win10 laptop, but the driver isn't signed for win10 so I dropped that approach. ![]() ![]() After connecting the USB Blaster to my Win7 computer for the first time and installing the driver from altera\11.1sp2\quartus\drivers, the USB Blaster shows up in the control panel as "USB-Blaster(Altera)" but Quartus II doesn't show it in the Programmer's Hardware Setup page. When you are prompted to Insert the disc that came with your USB-Blaster, select I don’t have the disc. Select Locate and install driver software (recommended). ![]() The Found New Hardware dialog box appears. serial programming and active serial modes Requires 5.0V from the USB cable and. Plug the USB-Blaster download cable into the PC. Because I have this Ep2c5/ep2c8 dev board, I've been following this video to begin my work with FPGAs: Buy PL-USB-BLASTER-RCN - Altera - Intel FPGA USB Download Cable.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |